FrSky Horus radios have good quality TFT display, so it is possible to have nice pictures of RC models.
The below pictures were adapted for FrSky Horus radios by myself, usually based on official product images or logos.
RC Models
Swashplate Leveler for XLPower Specter 700
3D printed swashplate leveler. Handy tool to setup proper geometry of RC helicopter main rotor head.
This one will work with XLPower Specter 700, or any model helicopter with 15mm main shaft and similar swashplate diameter.
MAK RC Signal Inverter
In RC hobby signal inversion may be required when connecting various components together, i.e. RC receivers to helicopter flybarless units or other flight controllers. This is particularly often required in case of one wire protocols, like SBUS, PPM or Smart Port – the last one being specific to FrSky products.
OpenTX – nitro helicopter config (and much more)
The OpenTX offers almost unlimited possibilities for configuring RC models. This article covers a detailed and quite advanced OpenTX configuration for a nitro helicopter, operating under control of MSH Brain 2 flybarless unit.
MAK Dynatron Heli Holder
The Sullivan Dynatron S603 is very popular, heavy-duty starter for gas and nitro RC model engines. Combined with Sullivan S613 Helicopter Extension Wand it creates great set for nitro helicopters, easily able to start 90 / 105 class nitro engine and which will last decades of usage.
Unfortunately plastic holder parts provided with the Dynatron are very basic and do not allow to mount the battery in compact, convenient way. That’s why I created my own holder, able to hold both battery and heli extension wand.
Synergy N7
My favourite RC heli so far – the famous Synergy N7, along with the best radio ever FrSky Horus X12S.
MAK RC Heli Servo Centering Tool
There are many servo testers and even some servo centering tools available on the market. I didn’t find though the one I wanted to have, with selectable 1500/1520µs PWM outputs and also with 760/960µs outputs for helicopter fast tail servos.
The MAK RC Heli Servo Centering Tool may be especially interesting for RC helicopter modellers, due to its fast tail servo PWM output. Of course Flybarless controller unit can be always used to center servos, but I like to mount FBL unit at very end, without bothering about it during the build process.
MAK RC Model Finder
There are many popular lost RC model finders available on the market. They are usually simple and inexpensive devices, activated by signal loss or inactivity on RC channel which they are connected to, after some pre-defined time.
They work, but they are rather cumbersome in use, as they often activate themselves in unwanted conditions, often on the ground, before a flight or after landing. They are also dependent on model’s power source and having small buzzers.
Thus I decided to develop my own lost model finder – MAK RC Model Finder (MRCMF) – under following assumptions: